The collar is where fin stock fails. Material that is a little too hard splits at the collar, and a split collar means poor contact with the tube and a heat exchanger that underperforms without looking wrong.
Specifications
| Item | Specification |
|---|---|
| Alloy | 1060 / 1100 / 3003 |
| Temper | O / H18 / H24 |
| Thickness | 0.02–0.2 mm |
| Width | 200–1333 mm |
| Minimum order, standard specification | 1 MT |
| Minimum order, custom specification | 6 MT |
Key Features
- Soft tempers that collar without splitting at the fin hole.
- Even gauge across the width, so fin height and stack pitch stay constant.
- Clean, evenly oiled surface for high-speed punching.
- Wound for long runs, so the fin line stops less often to change coils.
Applications
Punched into fins for the heat exchangers in air conditioning and refrigeration equipment.
- Room and commercial air conditioner coils
- Refrigeration and cold room evaporators
- Heat pump heat exchangers
- Condenser and evaporator assemblies
Ordering Information
Send us alloy, temper, thickness, width, coil inner diameter and quantity, and you will get a specific answer rather than a range. Standard specifications start at 1 MT; material made to your own drawing starts at 6 MT. If what you need falls outside the table above, send it anyway. We would rather say plainly that it does not fit our lines than take the order and miss the date.





