Products
SHEET AND COIL
Sheet, Coil and Strip
Mill finish plate, coil and strip off our own rolling lines. Everything further down this page starts as one of these.

Mill Finish Aluminum Sheet and Coil
1060, 1100 and 3003 in 0.2-3.0 mm.

Aluminum Strip
Slit to width from 200 mm.

Corrugated Aluminum Sheet
A corrugated profile stiffens thin material.

Aluminium Checkered Plate
Aluminium checkered plate is cold-rolled aluminium plate with a raised pattern rolled into one face.
SURFACE FINISHED
Surface Finished
Coil and sheet that leaves the line already coated or anodised, so colour and finish are settled before fabrication.

Color Coated Aluminum Coil
Polyester and PVDF, matched to RAL.

Color Coated Aluminum Sheet
Colour coated sheet is coated aluminium coil that has been levelled and sheared to length.

Anodized Aluminum Coil
Anodised coil carries an oxide layer grown into the aluminium rather than a film laid on top of it.

Anodized Aluminum Sheet
Anodised sheet is the cut-to-length form of anodised coil.

Brushed Aluminum Sheet and Coil
Brushed aluminium sheet and coil is cold-rolled aluminium sheet with a continuous fine grain brushed into the surface.

Mirrored Aluminum Sheet and Coil
The surface of mirrored aluminium sheet and coil is bright enough to give a clear reflection.
BUILDING AND INSULATION
Building and Insulation
Material shaped for roofing, cladding and insulation work: roll formed, coated, or cut to the widths those trades order in.

Insulation Aluminum Coil
Insulation coil is thin gauge aluminium wound in small coils and wrapped over thermal insulation.

Pipe Insulation Aluminum Coil
Pipe insulation coil is jacketing material slit to the width that wraps a given pipe and insulation thickness, including the overlap the specification calls for.

Roofing Aluminum Coil
Roofing coil is material rolled to feed a roll former, whether the panel ends up as standing seam, trapezoidal sheet or a shingle profile.

Color Coated Aluminum Roofing Sheet
Colour coated roofing sheet is coated aluminium coil run through a roll former into roof and wall panels.

Curtain Wall Aluminum Sheet
Curtain wall sheet is the flat stock behind an aluminium facade.
FABRICATION STOCK
Fabrication Stock
Stock rolled for the press and the tube mill, with temper and surface set for the forming step that follows.

Square Tube Aluminum Stock
Square tube stock is strip prepared for the lines that roll ceiling baffles and linear tube systems.

Cable Aluminum Strip
Cable strip is narrow gauge aluminium that goes into the armour, shield or sheath layer of a cable.

Stamping Aluminum Stock
Draws deep without tearing.

Aluminium Bar
Aluminium bar is a long aluminium product with a rectangular cross-section.

Aluminum Pieces
Aluminium pieces are aluminium sheet cut to the length and width you specify.
ALUMINIUM FOIL
Aluminium Foil
Foil rolled thin for packaging, fin stock and cable wrap, annealed to the temper each line asks for.

Container Foil
Formed trays in food contact quality.

Food Packaging Foil
Aluminium is the only common packaging material that blocks light, oxygen and moisture completely rather than slowing them down.

Air Conditioner Foil
Fin stock is the foil that gets punched into heat exchanger fins.

Hydrophilic Foil
Hydrophilic fin stock is finished so that condensate spreads into a thin film instead of beading up between the fins.