An order for colour coated coil often arrives as a RAL number and a thickness. Two further decisions sit behind it, and leaving them open is what leads to material that looks right on arrival and disappoints two years later.
The three decisions are the substrate under the paint, the coating system on top of it, and how colour is held consistent when the job runs across more than one batch.
The substrate is a structural choice, not a hidden one
Paint does not stiffen a panel. Whatever the coil has to do once it is formed and installed, it does on the strength of the metal underneath.
For panels that are roll formed and then have to stay flat over a span, 3003 is the usual substrate. Where the coil is mainly decorative, or is bent tightly during fabrication, 1100 is often enough. The temper matters here too: a coating line does not change how much cold work is left in the metal.
Coating systems
Two families cover most architectural and industrial work, and the choice between them is mostly a question of how long the colour has to survive outdoors.
| System | Holds up against | Usually specified for |
|---|---|---|
| Polyester | Ordinary indoor and sheltered outdoor exposure | Interior panels, ceilings, equipment housings, short service life outdoors |
| Fluorocarbon | Prolonged sunlight and weather, with better colour and gloss retention | Facade panels, roofing, anything expected to hold its colour for years outdoors |
Why colour drifts between batches
A RAL or Pantone reference names a target, not a tolerance. Paint batches, line speed and cure conditions all move the result slightly, which is why two coils coated months apart can read as different under daylight even when both are within specification.
It matters on a facade, where panels from different batches end up side by side on the same elevation. It matters much less on parts that are never seen together.
How to keep it under control
- Order the whole visible area in one batch wherever the quantity allows. This is the single most effective step and it costs nothing.
- Say at enquiry stage whether panels will be seen side by side. It changes how the job is planned, not just how it is inspected.
- Keep a retained sample from the approved coil and check later deliveries against it rather than against a colour card.
- If a repeat order is likely, say so at the outset. Matching to an earlier delivery is a different request from coating to a colour reference, and it is easier to plan for than to fix afterwards.
Our coating line runs 1100 and 3003 substrates in coil from 0.2 to 3.0 mm, in widths from 200 to 1333 mm, slit to order, in both polyester and fluorocarbon systems. Send the colour reference, the coating system if it is already decided, and a description of where the panels go, and we will confirm the substrate and temper with the quotation.