That matters when panels sit next to each other on a finished job. Sheets anodised one rack at a time drift in shade between racks, and the difference only shows up after the panels are installed.
Specifications
| Item | Specification |
|---|---|
| Alloy | 1060 / 1100 / 3003 |
| Temper | O / H18 / H24 |
| Thickness | 0.2–3.0 mm |
| Width | 200–1333 mm |
| Thickness tolerance | ±0.01 mm |
| Minimum order, standard specification | 1 MT |
| Minimum order, custom specification | 6 MT |
| Surface | Anodised oxide layer |
| Format | Cut to length |
Key Features
- Cut from anodised coil, so colour and gloss match across the whole pack.
- Hard oxide surface stands up to handling on site.
- Cut to the length you need rather than a standard sheet size.
- Stays dimensionally flat after cutting; no coil set left in the sheet.
Applications
Sheet is the format specified when panels are fabricated one by one rather than roll formed from a coil.
- Interior wall and ceiling panels
- Equipment and instrument panels
- Nameplates, signage and trim
- Furniture and display fittings
Ordering Information
Send us alloy, temper, thickness, width, coil inner diameter and quantity, and you will get a specific answer rather than a range. Standard specifications start at 1 MT; material made to your own drawing starts at 6 MT. If what you need falls outside the table above, send it anyway. We would rather say plainly that it does not fit our lines than take the order and miss the date.






